46
SYSTEM SETUP
EVENT / SENSOR - BUZZER OUT
Click on the BUZZER OUTPUT menu, and click on a field.
Use the button to modify the value.
This menu will determine the behavior and actions that will trigger the internal buzzer.
Behavior settings
OPERATION : The internal buzzer can be enabled or disabled.
HDD EVENT : Determines whether a hard drive event will activate the internal buzzer.
MODE : Can be set as either ‘TRANSPARENT’ (the buzzer sounds only when the trigger criteria is present)
or ‘LATCHED’ (the buzzer sounds for a set period of time after the trigger).
DURATION : In ‘LATCHED’ mode, the time that the buzzer will continue to sound after it has been triggered.
Action settings
ALARM : Determines whether alarm inputs will activate the internal buzzer.
VIDEO LOSS : Determines whether video loss on any of the selected channels will sound the internal buzzer.
MOTION : Determines whether motion detection on any of the selected channels will sound the internal buzzer.
NOTE: Remember to select ‘APPLY’ and press ‘ENTER’ to save all settings before exiting these menus.
To Next Page
Loading...
