Gap Diagnostic IIDTool Pro - Re-Enable EAS; Deflate Modes

118
IIDTool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
Press the up arrow to move corner(s) upwards and down to lower. Press Exit to return to normal
operations.
Note: It is preferable to adjust each axle separately avoiding air transfer from the front axle to the rear.
Please refer to the manufacturer’s FAQ located on the website for more details.
Re-Enable EAS
ThisroutineallowsnormaloperationoftheEAStoberesumedfollowingaDeateroutine.L322-02
This also allows normal operation of the EAS to be resumed following the use and exiting of the ‘Test
Valves’ function using ‘EXIT&KEEP TEST MODE’ .
Deate modes
Theseroutinesdeatetheentireairsuspensionsystem,airsprings,and/orreservoircompletely.
WARNING
Be sure deation can be safely performed before starting the
procedure! Make sure no objects or people are under the vehi-
cle or near any suspension components. Keep all doors closed.
If the vehicle is tted with non-standard wheels and/or tires (or
tyres), lowering the vehicle may cause a clearance issue. Tires
may come in contact with wheel arch or other.
Deationallowssaferemovalofairsuspensioncomponents.Threedeationmodesareavailable.
• DeateCorners(all4airsprings)
• DeateReservoir
• DeateAll
Note: Use the Re-Enable EAS function to return to normal operations.
CAUTION
Care should be taken when attempting to remove any air suspension
parts as there may be some residual pressure left in the system.
When removing a hose or a component, open connectors slowly and
wait until the sound of escaping air ceases. Defective parts can pre-
vent deation resulting in damage or personal injury.