Gap Diagnostic IIDTool Pro - Transmission; Adaption Clear (L322-06, L322-10, L319, 6 Speed)

124 125
IIDTool
GAP Diagnostic 2019-07-15 All Rights Reserved
User Manual : Version 33, Firmware V3.0
4.7.7 Transmission
Adaption clear (L322-06, L322-10, L319, 6 speed)
Gear shifting time tends to increase as internal components of a transmission wear out. This has a
negativee󰀨ectonthebrakeclutches.ThetransmissionECUwilladapttocounteractthee󰀨ectsof
wear and improve shifting.
This routine resets the adaption statistics back to factory default. After adaptions are cleared, the
transmission ECU will analyze shifting behaviours using various sensor readings and compensate
accordingly.
Usage
The adaption reset routine is necessary when at least one of the following components is replaced:
• Transmissionoil.
• Anycomponentinsidethetransmission.
• ThetransmissionECU.
• PriortoupdatingthetransmissionECUrmware.
CAUTION
The clear adaption routine may cause the transmission to behave
erratically over a period of time. It will need a few drive cycles to get
back to normal. Drive the vehicle normally and make sure that the
transmission shifts all gears.
Clearing adaptions shall only be performed following an oil
change, rmware ash or transmission repair. Clearing adap-
tions for no reasons on a transmission that is working correctly
may worsen its behaviour. In fact any non-needed work made on
a transmission that is working correctly may worsen its beha-
viour.