ERASING TRANSMITTER
RESET MOTOR MEMORY
Push simultaneously the PROG-TX button and
STOP of the transmitter until the motor makes a
brief movement in both directions.
Only the transmitter used for this procedure has
been deleted from motor memory.
OPTION 1 - Using an already programmed transmitter
Press and hold both the PROG-TX and STOP
buttons until the motor makes first a brief jog
and, after a while, a second, long jog. Memory is
now empty.
OPTION 2 - Without an already programmed transmitter
1
Switch the motor power supply OFF.
Then switch it ON.
OFF
ON
ON
2
Within 8 seconds, using any Gaposa
transmitter, press and hold both the
PROG-TX and STOP buttons until
the motor makes a long jog.
Memory is now empty.
x2
To Next Page
