HARDTOP LIFTER INSTALLATION
8. HardTop Lifter Adjustments (cont.)
3. If the hard top is leaning forward, move the vehicle and lower
the hardtop to the floor. Move the pulley sliders forward a little,
without changing the frame length adjustment; re-pin then lift
again. If leaning backward, move the sliders back.
4. Repeat until the load is balanced. (Adjustments are only
necessary during setup. Subsequent removals should not need
any adjustment.)
5. Lift to the ceiling. Set the “Upper Smart Point” in the App. Refer
to the MyLifter Manual for App instructions.
Do NOT run the Pulley Sliders into the myLifter.
CAUTION
ADJUSTMENTS
15
To Next Page
Loading...
Need help?
General
