48
ELECTRIC CONVECTION OVENS
EN
SWITCHING ON/OFF
When power is connected, the panel shows the
software version message for a few seconds. Then
the oven switches it self OFF, the LED on the time
display lights up and the oven remains in standby.
Pressing ON/OFF:
turns on the panel:
All the displays come on: the temperature display
flashes waiting for the set point to be entered:
default temperature 100 °C,
default timer 000,
default humidity 0,
MA default program display (manual oven mode).
Once the temperature has been set by pressing the
+ or - buttons, the display continues to flash for 15
seconds and then accepts the data entered, or, by
pressing the temperature button, the data entered is
accepted immediately, the display shows the fixed set
point and the time display flashes automatically.
Once the time has been set by pressing the + or -
buttons, the display continues to flash for 15 seconds
and then accepts the data entered, or, by pressing
the time button, the data is accepted immediately,
the display shows the fixed set point and the humidity
display flashes automatically.
Once the humidity data has been set by pressing the
+ or -
buttons, the display continues to flash for 15 seconds
and then accepts the data entered, or, by pressing the
humidity button, the data is accepted immediately.
At this point, all the displays are fixed, showing the
data set.
The programs display remains fixed in the MA position
and does not flash unless the P button is pressed to
enter programming mode.
During the cooking cycle, it is possible, while altering
the set parameters, pressing the corresponding
button (temperature, time, humidity) and using the +
and - buttons, to change the parameters, waiting for
15 seconds or pressing the corresponding button and
the program does not automatically move to the next
data as with the initial phase.
If the oven is in stop mode and no operation is
performed for more than 15 minutes, the oven
automatically switches off as if the OFF button had
been pressed.
The ON/OFF button is disabled during a cooking
cycle. To make it active, you must first press the
START/STOP button.
When the oven goes off, either because the ON/
OFF button has been pressed or at the end of a
cooking cycle, the last set parameters are stored for 5
minutes. 5 minutes after switch-off, the panel returns
to MA (manual) mode when switched back on.
3 - THIRD PART_Operating instructions
100
000
00
MA
To Next Page
Loading...
