---Press “MENU” to enter “SETTINGS” page, select “ ”, then press “OK”.
---Enter “AREA” page, press “OK” to start the mower, the mower walks counterclockwise on
the fence wire.
Press “OK” when the mower moves to the first memory point. The mower will keep on
moving, when the mower moves to the second memory point, press “OK”, when the mower
move to the third memory point, press “OK”.
After subarea setting is done, please turn off the mower, take the mower in front of the charging
station on the fence line and facing the charging station, then set the appointment time. See (2)
Programming Appointment.
Please refer to the attached images for Memory point 1, 2, 3 separately.
Notice:
A) It is better to set the memory point in the middle of the line between two corners.
B) The best position of the memory point is on the fence line which passes the center of
a small area
.
C) To ensure the mower walking smoothly, the max altitude difference between each two
small areas should not exceed 3cm. The minimum distance between two fence line
should be more than 50cm
.
To Next Page
Loading...
Need help?
General