EasyManua.ls Logo

Garmin 715 - Mounting on Your Dashboard; About GPS Satellite Signals

Garmin 715
66 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DRAFT
nüvi 705 Series Owner’s Manual 49
Appendix
To remove the cradle from the mount,
turn the cradle to the right or left. Apply
pressure in that direction until the cradle
snaps off the mount.
To remove the suction cup mount from
the windshield, ip the lever toward you.
Pull the tab on the suction cup toward
you.
Mounting on Your
Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and
comply with certain state regulations.
CAUTION: The permanent
mounting adhesive is extremely
difcult to remove after it is installed.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
adhesive on the bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from
the top of the disk.
5. Place the suction cup mount on top of
the disk. Flip the lever down (toward
the disk).
About GPS Satellite
Signals
Your nüvi must acquire GPS (Global
Positioning System) satellite signals to
navigate. If you are indoors, near tall
buildings or trees, or in a parking garage,
your nüvi cannot acquire satellites.
Go outside to an area free from tall
obstructions to use your nüvi.
When your nüvi has acquired satellite
signals, the signal strength bars on the
Menu page are green . When it
loses satellite signals, the bars turn red or
clear .
For more information about GPS, go to
www.garmin.com/aboutGPS.

Table of Contents

Related product manuals