Installation
Apollo SL30 Installation Manual
29
Sandel SN3308
ILS Enbl 33
NOTES: 1. Use shieled cable for resolver signals.
2. Connect cable shields to the mounting frame: pigtails < 1.25 inches.
3. Connect shields chassis ground at both ends of each shielded cable.
+GS Flag +GS Flag
-GS Flag
28
33
15
32-GS Flag
SL30
30
31
34
GSI Up
GSI Down
GSI Up
GSI Down
16
Composite
Gnd
19
37
Composite
ILS Enrgze
1029
827
NAV 1 NAV 2
4. Refer to Limitations on Using a Composite Signal paragraph in this chapter.
37-Pin Connector
5. Not all indicator connections are shown, only those interfacing to the SL30. Consult the
appropriate installation manuals for complete wiring instructions.
Figure 19 - SL30 NAV to Sandel SN3308 Converter Connections
To Next Page
Loading...
