Garmin Apollo SL30 COMM

To Next Page

To Previous Page

Serial Interface Specifications

Apollo SL30 Installation Manual

The data consists of five characters for the VOR station identifier followed by two characters

defining the VOR frequency.

Main Page

Installation Manual1
Table of Contents5
Section 1 - Introduction9
About this Manual9
Apollo Sl30 Description9
Eatures10
- General Features10
- Navigation Radio Features10
- Anel10
- Comm Radio Features11
- Physical Specifications11
- Nav Radio Performance Specifications11
- Comm Radio Performance Specifications11
System Interfaces12
- Navigation Receiver12
- Comm Transceiver12
- Serial12
- Erial Nterface12
Regulatory Compliance12
Npacking the Quipment13
Package Contents13
Ther Required Aterials14
Special Tools Required14
License Requirements15
Section 2 - Installation17
Pre -Installation Information17
Installation Overview17
Installation Considerations17
- Mounting Considerations17
- Minimum System Configuration17
- Mounting18
- Mounting Tube Installation18
Pacing19
- Unit Insertion20
- Unit Removal20
Electrical Connections22
- Power22
- Avionics Outputs22
- Serial Interface22
- Speaker and Headphone Outputs22
- Microphone Inputs23
- Transmit Key Input23
- Intercom Selector Switch23
- Remote Flip /Flop Input23
Antenna Installation and Connections23
- Comm and Nav Antennas23
- Use of Splitter and Combiner24
Equipment Interface25
Md200-306/30730
- Onnections31
- Ont Md200-306/30732
Iring34
Iring35
- Sing a37
- C Onnections37
- Pn-101 W Iring39
- Iring40
Nsd 360A40
Iring41
- Final System Check45
- F Eatures46
Limitations on Using a Composite Signal41
Imitations on Distance Speed and Time Nformation41
Post41
- Installation41
- Mounting / Wiring Check41
- Setup and Checkout41
Instructions for Continued Airworthiness48
Section 3 - Specifications49
Electrical49
Physical49
Nvironmental49
Avionics Outputs50
Nav Receiver Performance51
- Vor51
- Localizer51
- Glideslope52
- Obs Resolver52
- Composite Output52
Comm Receiver Performance53
Comm Transmitter Performance53
Intercom Performance54
Control Inputs54
Antenna Requirements54
- Comm Antenna54
- Nav Antenna54
Serial Interface55
Rear Connector Pinout55
Rate.57
Section 4 - Limitations57
Installation57
Computation Rates57
Operational57
Appendix A - Troubleshooting59
Contacting the Factory for Assistance60
Appendix B - Periodic Maintenance61
Vor Checks61
Equipment Calibration61
- Reference Oscillator (Comm Only )61
Cleaning the Front Panel61
Appendix C - Environmental Qualifications63
Appendix D - Accessories65
Appendixd - Accessories65
From Garmin At, Inc65
Appendix E - Serial Interface Specifications67
Input Commands67
Output Messages67
Data Format68
Default Message Output68
Message Formats68
Message Definitions69
- Input Messages69
- Emote vor List70
- Remote Localizer List72
- Request Data Output74
- Set Active Vor/Loc Frequency and Receiver Function75
- Set Standby Vor/Loc Frequency and Receiver Function75
- Requency and75
- Set Standby Comm Frequency and Transceiver Function76
- T Ransceiver F Unction76
- Set Omni -Bearing Select (Obs) Value77
- Dme Sensor Input78
Output Messages78
- Reset Status78
- CDI, Gsi, and Related Flags79
- Decoded Obs Setting80
- Radial from Active vor80
- Radial from Standby vor80
- Panel.80
- Decoded Station Identifier81
- Communications Error81
- Nav Receiver Status82
- Nav Audio Mode82
- Nav Microcontroller Software Version83
- Nav Dsp Software Version83
- Adc Data Output83
- Comm Transceiver Status84
- Comm Software Version84

Garmin Apollo SL30 COMM - Page 71

Table of Contents

Related product manuals