Garmin Apollo SL40 - Removing User Memory Frequencies; Replacing User Memory Frequencies

Removing a Frequency from User Memory
You may edit the contents of User memory to remove its
stored frequencies when you want to make a change or
you receive a “MEM Full” message.
1. Press RCL. Turn the Large knob to the
User (MEM) frequencies.
2. Press MEM. Turn Large knob to show
“Remove.”
3. Turn the Small knob to choose the
frequency to Remove.
4. Press MEM to remove the frequency.
Or, turn the Large knob to “Abort” and
press MEM to cancel and leave memory
as it was.
Replacing a Frequency from User Memory
You may edit the contents of User memory to replace its
stored frequencies when you want to make a change or
you receive a “MEM Full” message.
1. Select the desired new frequency with
the Large and Small knobs.
2. Press RCL. Turn the Large knob to the
User (MEM) frequencies.
3. Press MEM. Turn Large knob to show
“Replace.”
4. Turn the Small knob to choose the
frequency to Replace.
5. Press MEM to replace the displayed
stored frequency with the current
Standby frequency. Or, turn the Large
knob to “Abort” and press MEM to
cancel and leave memory as it was.
7
Basic Operation