ECHOMAP
™
UHD
INSTALLATION
INSTRUCTIONS
Important Safety Information
WARNING
Failure to follow these warnings, cautions, and notices could
result in personal injury, damage to the vessel or device, or poor
product performance.
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
When connecting the power cable, do not remove the in-line
fuse holder. To prevent the possibility of injury or product
damage caused by fire or overheating, the appropriate fuse
must be in place as indicated in the product specifications. In
addition, connecting the power cable without the appropriate
fuse in place voids the product warranty.
CAUTION
To avoid possible personal injury, always wear safety goggles,
ear protection, and a dust mask when drilling, cutting, or
sanding.
To avoid possible personal injury or damage to the device and
vessel, disconnect the vessel's power supply before beginning
to install the device.
To avoid possible personal injury or damage to the device or
vessel, before applying power to the device, make sure that it
has been properly grounded, following the instructions in the
guide.
NOTICE
For the best possible performance, the device must be installed
according to these instructions.
When drilling or cutting, always check what is on the opposite
side of the surface to avoid damaging the vessel.
Read all installation instructions before proceeding with the
installation. If you experience difficulty during the installation,
contact Garmin
®
Product Support.
ECHOMAP UHD 6x Connector View
POWER Power and data sharing
1
N2K NMEA 2000
®
network
XDCR 4-pin transducer
NOTICE
To prevent corrosion of the metal contacts, cover unused
connectors with weather caps.
ECHOMAP UHD 7x/9x Connector View
POWER Power and NMEA 0183 devices
NMEA 2000 NMEA 2000 network
SONAR 12-pin transducer
PANOPTIX Panoptix
™
LiveScope
™
sonar or Garmin Marine Network
for sharing sonar, LiveScope sonar, charts, and user data
NOTICE
To prevent corrosion of the metal contacts, cover unused
connectors with weather caps.
Software Update
You may need to update the chartplotter software after
installation. For the instructions on how to update the software,
see the owner's manual at garmin.com/manuals
/ECHOMAPUHD.
Tools Needed
• Drill
• Drill bits
◦ Bail mount: drill bits appropriate for the surface and
hardware
◦ Swivel mount: 3 mm (
1
/
8
in.) drill bit
◦ Flush mount: 3 mm (
1
/
8
in.) and 9.5 mm (
3
/
8
in.) drill bits
• #2 Phillips screwdriver
• Jigsaw or rotary tool
• File and sandpaper
1
If you are not connecting NMEA
®
0183 devices or another chartplotter to share
data, disregard the blue and brown wires.
TRA
REGISTERED No:
ER59438/17
DEALER No:
DA0015955/08
GUID-D4F04D40-7D5A-4040-AD3F-27506E0DAFD0 v3January 2021
To Next Page
Need help?
General
