Garmin FUSION - Installation Instructions Manual

HANDHELD MICROPHONE
INSTALLATION INSTRUCTIONS
Important Safety Information
WARNING
Failure to follow these warnings and cautions could result in personal injury, damage to the vessel, or poor
product performance.
See the Important Safety and Product Information guide in the stereo box for product warnings and other
important information.
This device must be installed according to these instructions.
Disconnect the vessel's power supply before beginning to install this product.
CAUTION
To avoid possible personal injury, always wear safety goggles, ear protection, and a dust mask when drilling,
cutting, or sanding.
NOTICE
When drilling or cutting, always check what is on the opposite side of the surface to avoid damaging the vessel.
You must read all installation instructions before beginning the installation. If you experience difficulty during
the installation, contact Fusion
®
Product Support.
Tools Needed
• Pencil
• Drill
• 16mm (
5
/
8
in.) drill bit
• 2.5mm (
3
/
32
in.) drill bit
• 16mm (
5
/
8
in.) socket or wrench
• Phillips screwdriver
• Marine sealant (optional)
GUID-1CD23792-2CC2-4768-B1BD-D1E11B6C23D8 v2November 2022