Garmin nuvi 660 User Manual

zūmo 660 Installation Instructions
Mount Your zūmo on the Motorcyle

Warning: Incorrectly wiring the power cable with bare wire leads can result in
damage to the vehicle or the battery and can cause bodily injury. Garmin strongly
recommends having an experienced installer with the proper knowledge of electrical
systems install the unit.
See the Important Safety and Product Information guide in the product box for product warnings
and other important information.
Step 1: Connect Power to the Mount
Select a suitable and secure location to mount the zūmo on your motorcycle, based on
available power sources and safe cable routing.
Cradle
Headphone/audio out jack (3.5 mm)
Microphone jack (2.5 mm)
Mini-USB connector
(for trafc receiever)
Bare wires with
inline fuse for
power connection
Power cable
Step 2: Install the Handlebar Base
The zūmo includes parts for two handlebar installation solutions. Custom mounts can
require additional hardware (www.ram-mount.com).
A) To install the U-bolt and handlebar base:
1. Place the U-bolt around the handlebar, and thread the ends through the handlebar
base.
2. Tighten the nuts to secure the base. Do not overtighten.

note: The recommended torque is 50 lbf-in. Do not exceed torque of 80 lbf-in.
Handlebar
base
Handlebar
U-bolt

Garmin nuvi 660 Specifications

General

Display Size	4.3 inches
Display Resolution	480 x 272 pixels
Preloaded Maps	Yes
Bluetooth	Yes
FM Transmitter	Yes
Touchscreen	Yes
Voice Prompts	Yes
FM Traffic Receiver	Yes
SD Card Slot	Yes
MP3 Player	Yes
Photo Viewer	Yes
Text-to-Speech	Yes
Weight	6.3 ounces (178 g)

Summary

Mount Your zūmo on the Motorcycle

Connect Power to the Mount

Select a suitable location to mount the zūmo and connect the power cable.

Install the Handlebar Base

Install the handlebar base using the U-bolt or clutch/brake clamp bracket methods.

Attach the Base Plate to the zūmo Mount

Thread screws through washers, cradle, spacers, and base plate, then tighten nuts.

Attach the Base Plate to the Handlebar Base

Align the ball of the handlebar base and base plate, tighten the knob to secure.

Install Your zūmo in the Mount

Fit the bottom of the zūmo into the cradle and tilt back until it snaps into place.

Remove Your zūmo from Mount

Press the release button on the side of the mount and lift the zūmo out.

Mount Your zūmo in an Automobile

Install the Cradle

Plug the automotive power cable into the cradle and secure the suction cup mount to the windshield.

Connect Power

Plug the automotive power cable into a power outlet and secure the traffic receiver antenna if applicable.