Tools and Supplies Needed
• Safety glasses
• Drill and drill bits
• Wrenches
• 90 mm (3.5 in.) hole saw or a rotary cutting tool (for installing an optional helm control)
• Wire cutters/strippers
• Phillips and flat screwdrivers
• Cable ties
• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a heat gun
• Dielectric grease
• Marine sealant
• Portable or handheld compass (to test for magnetic interference)
• White lithium grease
• Stainless steel tilt tube (required if the vessel does not have a stainless steel tilt tube installed)
• Thin cloth or small sponge (for cleaning the inside of the tilt tube)
NOTE: Mounting screws are provided for the main components of the autopilot system. If the provided screws
are not appropriate for the mounting surface, you must provide the correct types of screws.
2
To Next Page
