Garmin Vector - Default Chapter; Table of Contents

Table of Contents
Introduction.................................................................... 1
Thank You.................................................................................. 1
Getting Started........................................................................... 1
Tools Needed............................................................................. 1
Installing Vector Components.................................................... 1
Preparing the Crank Arms..................................................... 1
Determining Pedal Pod Clearance........................................ 1
Determining the Bicycle Chain Clearance............................. 1
Installing the Pedal Pod and Pedal....................................... 1
Installing the Shoe Cleats..................................................... 2
Adjusting the Release Tension............................................. 2
Pairing Vector with Your Edge 810 or 510 Device..................... 2
Your First Ride........................................................................... 2
Entering the Crank Length.................................................... 2
Setting the Installation Angle................................................. 2
Performing a Static Zero Calibration..................................... 2
Calibrating Vector Before Each Ride.................................... 2
Customizing the Data Fields................................................. 3
Training........................................................................... 3
Pedal-Based Power................................................................... 3
Maintenance Tips....................................................................... 3
Vector Data..................................................................... 3
Sending Your Ride to Garmin Connect...................................... 3
Garmin Connect.................................................................... 3
Disconnecting the USB Cable............................................... 3
Device Information.........................................................3
Vector Device Care.................................................................... 3
Removing the Pedal Pod and Pedal.......................................... 4
Replacing the Pedals and Cartridges........................................ 4
Vector Storage........................................................................... 4
Vector Specifications................................................................. 4
USB ANT Stick™ Specifications................................................ 4
Battery Information..................................................................... 4
Replacing the Pedal Pod Battery.......................................... 5
Appendix.........................................................................5
Registering Vector..................................................................... 5
Edge 800 Device Instructions.................................................... 5
Pairing Vector with the Edge 800 Device.............................. 5
Calibrating Vector with the Edge 800 Device........................ 5
Edge 500 Device Instructions.................................................... 5
Pairing Vector with the Edge 500 Device.............................. 5
Calibrating Vector with the Edge 500 Device........................ 5
Customizing the Data Fields................................................. 6
Power Data Fields...................................................................... 6
Troubleshooting......................................................................... 6
Updating the Software Using Vector Updater....................... 6
Third-Party Devices............................................................... 6
Index................................................................................7
Table of Contents i