GARO GNM1D-RS485 - Set Modbus Address

5
7
EN
GNM1D-RS485
GNM1D-RS485
GNM1D-RS485
GNM1D-RS485
Set the Modbus Address
1. Press lower touch area 3 seconds and ”current Modbus Address is visible.
2. Click upper or lower touch area to modify the blinking figure.
3. Press lower touch area 2 seconds to change to next figure. Repeat step 2 and 3 until the wanted adress is visible.
4. Confirm by press lower touch area 2 seconds.