Name: GARO GNM1D-RS485
Brand: GARO
Rating: 4 (1 reviews)

To Previous Page

GNM1D-RS485

Final step

3. Press lower touch area 2 seconds to confirm and current stopbit setting is visible.

4. Press lower touch area 2 seconds and stopbit value is visible. Correct value is ”1”. Click upper touch area to change the value if

needed.

5. Confirm by press lower touch area 2 seconds. PArItY is visible.

1. Click upper touch area until you see End is visible. Press and hold lower touch area for 3 seconds or wait for 2 min to leave

programming mode.

Questions and Answers:

Need help?

Do you have a question about the GARO GNM1D-RS485 and is the answer not in the manual?

GARO GNM1D-RS485 Specifications

General