Garrard ZERO 100C - Setting Up and Cabling; Cabling Instructions; AC Power and Ground Connection

CABLING INSTRUCTIONS.
Your Garrard Zaro 100¢ turntable can be used with elther mono or
stereo sound systems as described below.
Note: R.C.A. type output connectors are used on this turntable
AC. POWER SUPPLY AND GROUND CONNECTIONS
The brown AC power supply cable should be plugged into the
ower outlet on the amplifier or, if this is not provided, into a wall
Socket. The green (or green and yellow) ground leed should be
Gonnested toa ground connection on the amplifier chassis oF
Girectly to ground. The amplitier manutact
give more detailed advico.
CONNECTING A STEREO CARTRIDGE TO A STEREO AMPLIFIER
Plug both pheno leads into the amplifier input sockets as shown
in @agrem 6. Make certain that the right-hand pickup output
Cchennol (R) ia connected to the amplifier input fooding the right
han speaker end that te left-and output channel (L) is
Connected to the input feeding the lefthand speai
CONNECTING A MONO CARTRIDGE TO A STEREO AMPLIFIER
Plug in the phono lead as shown on diagram 7.
pickup output channel (R) it the ted and green
farm cariridge carrier are connected to the cartridge output pins
and the left-hand output channel (L) if the white and blue I
fro connected to the cartridge. Use the 'Y' adaptor only i
amplifier has no provision for connecting both input chennals
togothor in paral
CONNECTING A STEREO CARTRIDGE TO A MONO AMPLIFIER
Plug both phono leads into a “Y' i
so that tne complete output signal trom the cartridge will be
Tepreduced through the sound system.
+ Refer to the amplifier manufacturer's instructions for the selection
‘of amplifir input level for the type of cartridge in us
AG. Power
Sha Groand
Connections
Steree
Cartridge
Stereo Amp
Gennections
Dugan 6
Cenridge—
Stores Ame
Connections
Stores
Garridge—
Mono Aro
Gonnectione
Bottom
Turntable
rus
[oom
©O]vr80"
Pus
nto
Frnousi
S52
ft ‘Channel Preamp
O|fO] | ers Mans
pia LoLevel*
ap
imps EE
om
JO) bo Lone