EasyManua.ls Logo

GAS GAS EC 350F - User Manual

GAS GAS EC 350F
150 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
OWNER'S MANUAL 2021
EC 350F
Art. no. 3215013en

Table of Contents

Questions and Answers

  • S
    seangarrettAug 18, 2025
    What to do if my GAS GAS EC 350F Motorcycle engine cannot be cranked?
    • B
      Brooke WilliamsonAug 18, 2025
      If your GAS GAS Motorcycle engine won't crank, possible causes include: * **Operating error:** Ensure you are following the correct start procedure. * **Discharged 12-V battery:** Charge the battery, and check the charging voltage, open-circuit current, and alternator stator winding. * **Blown main fuse:** Replace the main fuse. * **Defective starter relay:** Check the starter relay. * **Defective starter motor:** Check the starter motor.
  • C
    Carla VillanuevaAug 23, 2025
    Why does my GAS GAS EC 350F Motorcycle engine have too little power?
    • C
      Courtney AllenAug 23, 2025
      If your GAS GAS Motorcycle engine has too little power, consider the following: * **Air filter:** Clean the air filter and air filter box if heavily contaminated. * **Fuel filter:** Change the fuel filter if it is very dirty. * **Fuel screen:** Change the fuel screen if it is very dirty. * **Electronic fuel injection:** Read out the fault memory using the GAS-GAS Motorcycles diagnostics tool. * **Exhaust system:** Check the exhaust system for leaks or deformation. Change the glass fiber yarn filling in the main silencer if there is too little. * **Valve clearance:** Adjust the valve clearance if it's too little.
  • S
    Shannon CantrellAug 26, 2025
    What to do if my GAS GAS Motorcycle engine overheats?
    • J
      Jordan MccartyAug 26, 2025
      If your GAS GAS Motorcycle engine is overheating: * **Coolant level:** Check the cooling system for leaks and check the coolant level. * **Airflow:** Switch off the engine when stationary to prevent insufficient airflow. * **Radiator fins:** Clean radiator fins if they are very dirty. * **Cooling system foam:** Drain and refill the coolant to address foam formation. * **Radiator hose:** Change the radiator hose if it's bent. * **Thermostat:** Check the thermostat.
  • D
    Dawn SanchezAug 28, 2025
    What to do if my GAS GAS EC 350F engine does not speed up?
    • J
      Jill JonesAug 28, 2025
      If your GAS GAS Motorcycle engine does not speed up, consider these possible solutions: * **Electronic fuel injection:** Use the GAS-GAS Motorcycles diagnostics tool to read out the fault memory. * **Ignition system:** Check the secondary winding of the ignition coil, the spark plug connector, and the stator winding of the alternator.
  • M
    martinezdanielAug 30, 2025
    What to do if my GAS GAS EC 350F engine dies during the trip?
    • D
      Dorothy BennettAug 30, 2025
      If your GAS GAS Motorcycle engine dies during a trip, consider these potential causes: * **Lack of fuel:** Refuel your motorcycle. * **Blown fuse:** Replace fuse 1 or fuse 4.
  • J
    Jessica BradySep 2, 2025
    Why is my GAS GAS EC 350F Motorcycle using high oil consumption?
    • A
      Antonio CortezSep 2, 2025
      If your GAS GAS Motorcycle has high oil consumption: * **Engine vent hose:** Ensure the engine vent hose is not bent; reroute it or replace it if necessary. * **Engine oil level:** Check the engine oil level and correct if it is too high. * **Engine oil viscosity:** Change the engine oil and oil filter, and clean the oil screen if the engine oil is too thin. * **Piston and cylinder:** Measure the piston/cylinder mounting clearance to check for wear.
  • A
    Amy WilliamsSep 4, 2025
    What does it mean if malfunction indicator lamp lights up or flashes on my GAS GAS EC 350F Motorcycle?
    • L
      lreedSep 5, 2025
      If the malfunction indicator lamp lights up or flashes on your GAS GAS Motorcycle, it indicates an error in the electronic fuel injection. You should check the wiring for damage and the electrical plug-in connectors for corrosion and damage. Also, read out the fault memory using the GAS-GAS Motorcycles diagnostics tool.
  • R
    Robert LeonSep 7, 2025
    Why is my GAS GAS EC 350F 12-V battery discharged?
    • M
      Mrs. Christina TaylorSep 7, 2025
      If your GAS GAS Motorcycle's 12-V battery is discharged, it could be due to: * **Alternator not charging the battery:** Check the charging voltage and the stator winding of the alternator. * **Unwanted electrical power consumer:** Check the open-circuit current.
  • D
    David BuckSep 9, 2025
    What to do if high beam, low beam, tail light, position light, and license plate lamp are not working on my GAS GAS EC 350F?
    • D
      Donald JohnsonSep 9, 2025
      If the high beam, low beam, tail light, position light, and license plate lamp are not working on your GAS GAS Motorcycle, the cause may be a blown fuse 2. Replace the fuse.
  • A
    Aaron PerrySep 12, 2025
    What to do if horn, brake light, turn signal, and radiator fan are not working on my GAS GAS Motorcycle?
    • T
      tanya32Sep 12, 2025
      If the horn, brake light, turn signal, and radiator fan (if equipped) are not working on your GAS GAS Motorcycle, it may be due to a blown fuse 3. Replace the fuse.

Summary

Safety Advice

General Safety Instructions

Provides essential safety advice and guidelines for operating the motorcycle.

Risk Levels and Symbols

Explains the different degrees of risk and their corresponding symbols.

Safe Operation Guidelines

Outlines critical rules and conditions for safe and proper vehicle operation.

Controls

Start Button and Indicators

Explains the start button and the meaning of indicator lamps.

Steering Lock Operation

Instructions for locking and unlocking the motorcycle's steering.

Combination Instrument

Instrument Overview and Settings

Describes the instrument layout, activation, messages, and basic settings.

Average Speed and Operating Hours

Shows how to view average speed, operating hours, and total distance covered.

Preparing for Use

First Use Preparation and Safety

Provides essential advice and safety precautions before the initial ride.

Engine Break-in Procedures

Guides on proper engine running-in to ensure optimal performance and longevity.

Vehicle Preparation for Conditions

Details preparations for difficult conditions like sand, mud, and temperature extremes.

Riding Instructions

Pre-Ride Checks and Maintenance

Lists critical checks and maintenance tasks to perform before riding.

Starting and Riding Procedures

Guides on starting the vehicle, starting off, and shifting gears while riding.

Braking, Stopping, and Parking

Provides instructions and warnings for effective braking and safe parking.

Transporting and Refueling

Details safe procedures for transporting and refueling the motorcycle.

Service Schedule

Required and Recommended Work

Lists mandatory and recommended maintenance tasks with intervals.

Tuning the Chassis

Basic Chassis Setup Adjustment

Guides on adjusting chassis settings based on rider weight for optimal handling.

Shock Absorber Damping Adjustments

Explains low-speed and high-speed compression, and rebound damping adjustments.

Shock Absorber Sag Measurement

Details how to measure static and riding sag for shock absorber tuning.

Service Work on the Chassis

Brake System

Front Brake Fluid and Linings

Procedures for checking/adding front brake fluid and changing linings.

Front Brake Linings Replacement

Detailed steps for changing the front brake linings.

Rear Brake Fluid and Linings

Procedures for checking rear brake fluid and linings.

Rear Brake Linings Replacement

Detailed steps for changing the rear brake linings.

Wheels, Tires

Electrical System

Cooling System

Coolant Level and Antifreeze Check

How to check the coolant level and antifreeze protection.

Tuning the Engine

Idle Speed and Throttle Valve Programming

Procedures for adjusting idle speed and programming throttle valve position.

Service Work on the Engine

Engine Oil Level and Oil;Filter Change

How to check engine oil level and procedures for oil/filter change.

Adding Engine Oil

Procedure for adding engine oil to the correct level.

Cleaning, Care

Storage

Troubleshooting

Blink Code

Technical Data

Engine and Chassis Tightening Torques

Lists torque specifications for various engine and chassis components.

GAS GAS EC 350F Specifications

General IconGeneral
BrandGAS GAS
ModelEC 350F
CategoryMotorcycle
LanguageEnglish

Related product manuals