Why is black smoke coming out of my GAS GAS Motorcycle exhaust?
Black smoke from the exhaust of your GAS GAS Motorcycle can be caused by a restricted air filter or a main jet that is too high. Try replacing or cleaning the air filter and verifying the main jet.
Why does my GAS GAS Motorcycle have detonations from the exhaust?
Detonations from the exhaust of your GAS GAS Motorcycle can occur due to several reasons. It may be caused by incorrect octane or poor quality gasoline, so drain all gasoline and fill up with a higher octane or new fuel. A damaged spark plug or incorrect specification can also be the cause, so replace the spark plug with a new one of the correct type. Check the exhaust gaskets for deterioration and replace them if they are not in perfect condition.
What to do if my GAS GAS EC250E 2012 Motorcycle engine lacks power or has poor acceleration?
If your GAS GAS Motorcycle engine lacks power or has poor acceleration, the issue could stem from a defective fuel supply, a dirty air filter, a leaking or deteriorated exhaust, or dirty carburetor jets. You can clean the fuel system, replace or clean the air filter, verify the exhaust for damage, or disassemble the carburetor and clean all jets.
What to do if my GAS GAS Motorcycle engine overheats?
If your GAS GAS Motorcycle engine is overheating, it could be due to insufficient coolant or a radiator that is dirty or partially restricted. Fill up the coolant and check the refrigeration system for watertightness. Also, clean the radiator fins or replace the radiator.
What to do if my GAS GAS EC250E 2012 engine does not start?
If your GAS GAS Motorcycle engine won't start, several factors could be at play. If the motorcycle has been inactive for a long time, unload the old fuel and fill the tank with new fuel. Check if the spark plug is dirty or wet, and clean, dry, or replace it as needed. If the engine is flooded, close the fuel tap, remove the spark plug, put a gear and push the bike several feet with the throttle fully open. Mount the spark plug and start the bike. Incorrect air/fuel mixture can also be a cause, so clean the fuel tank breather and air filter. Finally, ensure the exhaust valve is correctly positioned.
What to do if my GAS GAS Motorcycle electric starter motor does not crank?
If the electric starter motor on your GAS GAS Motorcycle doesn't crank, check the starter relay fuse and the battery. Remove the seat and check the fuse. Also, remove the seat and check the battery voltage.
What to do if my GAS GAS EC250E 2012 engine operates irregularly?
If your GAS GAS Motorcycle engine operates irregularly, check the spark plug for dirt or misadjustment, and clean, tighten, or replace it. Also, verify the spark plug condition and replace it if deteriorated, if there is poor contact between the spark plug and spark plug cap. Replace the rotor, if the ignition rotor is damaged. If there is water in the fuel, drain the fuel tank and fill up with new fuel.
What to do if my GAS GAS Motorcycle engine starts but then stops?
If your GAS GAS Motorcycle engine starts but then stops, it might be due to an incorrect air supply or lack of fuel. Close the starter, clean the fuel tank air vent, and adjust the air cleaner duct to address air supply issues. If there's no fuel, fill up the fuel tank.
What to do if gears do not engage correctly on my GAS GAS EC250E 2012 Motorcycle?
If the gears on your GAS GAS Motorcycle do not engage correctly, it might be due to a damaged gearshift pedal. Try replacing the gearshift pedal.
Identification and numbering of key motorcycle controls and components.
Wiring diagram for EC models.
Wiring diagram for CrossCountry models.
Instructions for configuring gauge settings like units and time.
Essential pre-ride checks for safety and maintenance.
Summary table of maintenance intervals and tasks.
Guidance on adjusting carburetor for optimal performance.
Instructions for adjusting front and rear suspension settings.
Solutions for engine not cranking or starting problems.
Troubleshooting for engines that start and then stop.
Causes and solutions for engine overheating.
Troubleshooting for brake and lighting system malfunctions.
General| Year | 2012 |
|---|---|
| Manufacturer | GAS GAS |
| Model | EC250E |
| Engine Type | Single Cylinder, 2-Stroke |
| Displacement | 249.3 cc |
| Bore x Stroke | 66.4 x 72 mm |
| Lubrication System | Premix |
| Ignition System | CDI |
| Transmission | 6-speed |
| Frame | Aluminum |
| Front Tire | 90/90-21 |
| Rear Tire | 140/80-18 |
| Seat Height | 960 mm |
| Category | Enduro |
| Cooling System | Liquid-cooled |
| Fuel System | Carburetor |
| Clutch | Wet multi-disc |
| Front Brake | Hydraulic disc |
| Rear Brake | Hydraulic disc |
| Fuel Capacity | 9.5 L |
To Next Page