31
www.gateway.com
Connecting to a wired Ethernet network
Connecting to a wired Ethernet network
Your computer has a network jack that you can use to connect to a 10/100 wired Ethernet
network.
To connect to a wired Ethernet network:
1 Insert one end of the network cable into the network jack on the back of your
computer.
2 Insert the other end of the network cable into a network jack.
Important
Your computer is equipped with a built-in Ethernet port.
For information about setting up a wired or wireless Ethernet network,
see “Networking Your Computer” on page 81.
Tips & Tricks
You can use your computer’s Ethernet jack for more than just
networking. Many broadband Internet connections, such as cable
modems and DSL modems, connect to your computer’s Ethernet
jack. For more information, see “Using the Internet” in
Using Your
Computer
which has been included on your hard drive. To access this
guide, click Start, All Programs, then click Gateway
Documentation.
To Next Page
Loading...
