Gateway Remote Control - Searching for component codes; To search for a component code

20
Remote Control User’s Guide
www.gateway.com
Searching for component codes
If you cannot find your manufacturer in the component list or the program
code does not work, you can use the remote control to search for the correct
component code.
To search for a component code:
1 Turn on the component.
2 Press the matching component button on the remote control.
3 Press and hold SETUP until the LED flashes twice.
4 Press 9 9 1. The LED flashes twice.
5 Point the remote control at the component and alternate between pressing
POWER and the component button on the remote control until the
component turns off.
If the component still does not respond, clear the component button, then
repeat the search procedure.
To clear the component button:
1 Make sure that the component is turned on.
2 Press and hold the SETUP button on the remote control until the LED
flashes twice.
3 Press 9 9 2, then press the component button on the remote control twice.