21
Programming the remote control
www.gateway.com
Reassigning component buttons
You can reassign the component buttons on the remote control if you have
more than one of the same type of component.
Example:
If you are using the remote to control the cable (CBL), DVD, TV, and two VCRs,
you can reassign the CD button as a second VCR button.
To reassign component buttons:
1 Press and hold SETUP until the LED flashes twice.
2 Press 9 9 2. The LED flashes twice.
3 Press the component button that you want (VCR) once, then press the
component button that you are reassigning (
CD) once. The CD button is
now reassigned and can be programmed as a VCR component button. See
“Programming the remote control” on page 8.
Changing volume lock
The remote control can be set to control volume through your TV while in cable
(CBL), DVD, CD, and VCR component modes. Use the volume lock if you want
to control the volume for all components through a specific component.
Example:
You want to control volume for all components through the receiver (AUX).
To reassign component buttons:
1 Press and hold SETUP until the LED flashes twice.
2 Press 9 9 3. The LED flashes twice.
3 Press the component button that you want (AUX) once. The LED flashes
twice. Volume will now be controlled through the receiver for all
components.
To Next Page
Loading...
Need help?
General