Gateway Solo 2100 - Suspend;Resume and Battery Features

60 Gateway Solo™ 2100 Multimedia Notebook
Suspend timeout:
The time that the system waits
after the notebook is in Standby mode, before
going into Suspend mode. The Power Management: function must be set to
Customize before you can change this field. Use the Spacebar to choose 2 ,
4, 6, 8, 10... through 30, or Off.
Hard disk timeout:
The time that the system waits before the hard drive spins down into a ”rest“
mode. The Power Management: function must be set to Customize before you
can change this field. Use the Spacebar to choose 2 , 4, 6, 8, 10... through
14, or Off.
Video timeout:
The time that the system waits before going into ”video rest.“ The Power
Management: function must be set to Customize before you can change this
field. Use the Spacebar to choose 2, 4, 6, 8, 10... through 14, or Off.
Resume on time:
Turning this feature On will ”wake“ the system up at the time specified in the
Resume time: field. Use the Spacebar to select On or Off.
Resume time:
Sets a specific time the system will ”wake“ from Suspend mode. Use the Tab
key to access each field and type in the desired values.
Battery low suspend:
When this feature is enabled, the system automatically enters Suspend mode
when the battery gets low. Use the Spacebar to select On or Off.
Auto dim with battery only:
When this feature is enabled, the LCD brightness automatically decreases by
50% when using battery power only. Use the Spacebar to select On or Off.
Press the Esc key to access the Exit menu and accept/discard changes. Press
F9 to return to the factory defaults, and F10 to return to the previous set-
tings. Use the Right Arrow key to tab over to the next screen.
à
See page 50.