Chapter 2: Getting Started 19
2.
Plug the AC power adapter into the notebook power connector on the
right side of the notebook near the back.
3.
Plug the power cord into an electrical outlet.
Starting up your notebook
Once the battery is installed and the AC power adapter is plugged in you will
see the battery icon , the AC power icon , and the charge icon .
1.
Slide the LCD panel latch to the right to release and open the LCD
panel.
2.
Tilt the LCD panel to adjust for the proper viewing angle.
3.
Press the power button to turn your computer on.
To startup the computer
Note:
The power button is preset
to On/Off mode. You can
set it to function either in
On/Off or Standby/Resume
mode using the BIOS setup
program. See “Setting the
power button” on Page 60
for more information about
changing power button
modes.
To Next Page
Loading...
