Gateway Solo 2500 - Swapping the Battery Pack

Chapter 4: Managing Power Usage 57
Swapping the battery pack
Battery packs can be “warm-swapped”. This means you can change battery
packs while in Suspend mode (Windows 95) or Standby mode (Windows
98).
The backup battery that supports warm swapping has a limited power
supply (about ten minutes). Make the battery swap quickly to conserve the
backup battery power.
1.
Save all work.
2.
If you are using Windows 95 or NT click Start on the taskbar, then
Suspend to put the system into suspend mode.
- OR -
If you are using Windows 98 click
Start on the taskbar, then click Shut
Down, Standby, then OK to put the system into standby mode.
- OR -
Shut down the system.
3.
Close the LCD panel and turn your notebook over.
4.
Slide the battery release latch to release the battery pack.
To remove the battery pack