The ProCut 20P should be located in a space that allows
adequate room to operate the machine. Allow at least
six inches behind the machine. It is recommended that
a media table be used to stage the sheets to be cut.
A second media table is recommended for nished
material. Keep the working area of the cutter free from
clutter.
Avoid locating the cutter in a high trafc area. When not
in use, the ProCut 20P can be unplugged.
Operator
Media Table Media Table
6 inches
12 inches
Figure 2. ProCut 20P Location
To Next Page
Loading...
Need help?
General
