Page 8
gcode example:
;I am a note. Insert lots of me to remember specific commands
M201 X800 Y800 Z50 E1000 ; sets maximum accelerations, mm/sec^2
M107 ; Turn fan off
M104 S245 ; set temperature
G28 ; home all axes
M109 S245 ; set temperature and wait for it to be reached
G21 ; set units to millimeters
G90 ; use absolute coordinates
M83 ; use relative distances for extrusion
G92 E0 ; Reset extruded amount
;TYPE:Skirt
;WIDTH:0.5625
G1 F1200.000
G1 X200.438 Y181.307 E0.06965 ; move extruder and extrude filament
G1 X201.273 Y181.349 E0.05195
M600 ; Initiate filament change
.
.
Common gcode commands
G28 ; Home all axis
G29 ; Level bed (Don’t use in start gcode)
M420 V1 T1 ; Display bed leveling data
M600 ; Initiate filament change
M107 ; Turn off fan
G1 X10 Y10 Z10 F1000 ; Move extruder to XYZ
position at “1000” speed
Firmware
Description
Firmware is the software that lives on the printer and LCD boards to control the printer. Firmware can
periodically be updated to unlock new features or fix existing bugs. Please make sure to download the
latest firmware for your printer from the gCreate websites and not directly from the source github.
To Next Page
Loading...
