30
5. Press the MEM/CONFERENCE (base) or MEMORY/conference (cordless handset)
button again to save your selection. The display shows ENTER TEL NUMBR.
NOTE: If you make a mistake, press the DELETE button on the base
or CHAN/delete on the handset to backspace and erase the wrong
character(s) or number(s).
6. Use the touch-tone pad to enter the area code followed by the telephone number
(up to 4 digits, including pauses) and press the MEM/CONFERENCE (base) or
MEMORY/conference (cordless handset) button again to save your selection. The
unit beeps to conrm.
7. To enter another name and number in a different memory location, return to step 1
and repeat the process.
Storing a Redial Number
1. Make sure the phone is OFF (not in TALK mode).
. Perform steps 1 through 5 from the previous section, Storing A Name And Number
In Memory.
3. Press REDIAL to display the redial number and name.
4. Press the MEM/CONFERENCE (base) or MEMORY/conference (cordless handset)
button again to conrm.
NOTE : If the number you want to redial has more than 24 digits,
the telephone number cannot be stored in memory.
Inserting a Pause in the Dialing Sequence
Press the #PAUSE button (base) or the PAUSE# (cordless handset) on the touch-tone pad
to insert a delay in the dialing sequence of a stored telephone number when a pause
is needed to wait for a dial tone (for example, after you dial 9 for an outside line, or wait
for a computer access tone.) Each pause counts as 1 digit in the dialing sequence.
Reviewing, Changing or Deleting Stored Names/Numbers
To Review: Press the MEM/CONFERENCE (base) or MEMORY/conference (cordless
handset) button, then press the REVIEW or NEXT button (base) or the VOL/CID (- or +)
button (cordless handset) to scroll through the stored numbers. Or press the memory
location number.
To Next Page
Loading...
Need help?
General
