GE 27881 - You experience static, noise, or fading in and out; Unit locks up and no communication between the base and cordless handset; Caller ID Solutions

41
You experience static, noise, or fading in and out
• Change channels.
• The cordless handset may be out of range of the base. Move closer to the base.
• Make sure base is not plugged into an outlet with another household appliance.
• Charge the battery.
Unit beeps
• Place the handset in the cradle for 0 seconds. If it still beeps, charge battery for
16 hours.
• Clean charging contacts on cordless handset and charge cradle with a soft cloth
or an eraser.
• See solutions for “No dial tone” on previous page.
• Replace the battery.
Memory Dialing doesn’t work
• Did you program the memory location keys correctly?
• Did you follow proper dialing sequence?
Unit locks up and no communication between the base and cordless handset
• Unplug the AC power adaptor from the wall outlet and the back of the base.
Remove the handset battery. Wait for 30 seconds and plug the AC power
adaptor back into the base and wall outlet. Reconnect the battery and charge
for 16 hours.
Caller ID Solutions
No Display
• Is battery fully charged? Try replacing the battery.
• Make sure that the unit is connected to a non-switched electrical outlet.
Disconnect the AC power adaptor from the base and reconnect it.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid Caller ID
information during the silent period after the rst ring. This message indicates
the presence of noise on the line.