GE 27956FE1 - Answering Calls; Inserting a Pause in the Dialing Sequence; Redial

9
Answering Calls
1. When the phone rings, press the talk/call back button.
. When nished, press the talk/call back button or put the handset back into the
cradle to hang up.
NOTE: If you have turned the Auto Talk function on, you can pick
up the handset from the base to answer the incoming call directly,
without pressing any buttons.
NOTE: Adjust the handset volume by pressing the
cid/vol (3or4)
button during a call.
Inserting a Pause in the Dialing Sequence
Press the #pause button twice to insert a delay in dialing sequence when a pause is
needed to wait for a dial tone (for example, after you dial 9 for an outside line, or to
wait for a computer access tone.) The screen displays a pause as a P, and each pause
counts as one digit in the dialing sequence.
Redial
To quickly redial a number you dialed:
1. Make sure the phone is OFF (not in talk mode).

. Press the talk/call back button.

. Press the redial button rst, then use the cid/vol (3or4) button to select the
desired redial number.
NOTE: You may choose from 10 last dialed numbers.
4. Press the menu button. The number dials automatically.
-OR-
1. Make sure the phone is OFF (not in talk mode).

. Press the redial button. Then use the cid/vol (3or4) button to select the desired
redial number.
NOTE: You may choose from 10 last dialed numbers.
. Press the talk/call back button. The number dials automatically.