GE 29897GE1 - Setting the Regional Area Codes

15
1. If you just adjusted the Remote Access menu, skip to step 2. If you haven’t adjusted
any other setting, press and release the MENU button until DIALING is displayed.
2. Use NEXT or REVIEW or press the keypad number for the desired setting (1 for
pulse, 2 for tone).
3. When nished, press ENTER to conrm. The unit beeps.
NOTE: To skip to the next setting, press MENU. To exit setup, press
EXIT.
Setting the Regional Area Codes
Depending on your area, you may need to set regional area codes. These are needed
in order for the phone to determine the number format to be displayed when a valid
Caller ID signal is received. Calls received that match any of the regional area codes
are displayed as 10 digits. If the number is not displayed correctly, the phone may not
be able to dial back the number properly. You can store up to 6 regional area codes.
You may need to use this feature if you have:
• Multiple area codes
• Overlapping area codes
• Areas that require 10-digit dialing.
1. If you just adjusted the Dialing menu, skip to step 2. If you haven’t adjusted any
other setting, press and release the MENU button until REGIONAL AC# is displayed.
The rst digit of code #1 ashes.
2. Use NEXT or REVIEW to set the rst digit.
3. Press ENTER. The next digit ashes.
4. Repeat steps 2-3 until all the digits of the regional area code are set.
5. When nished, press ENTER to conrm. The unit beeps.
NOTE: If you don’t want to enter any more area codes, press MENU.
To exit setup, press EXIT.