Why is there no conditioned water after regeneration in my GE Water System?
If your GE Water System is not providing conditioned water after regeneration, it could be due to a lack of salt in the brine tank, so add salt to the brine tank. Another cause could be a plugged injector, so clean the injector and screen. The air check valve might also be closing prematurely, so put the control momentarily into brine/slow rinse.
Why is my GE Ranges smoking so much when broiling?
If your GE Ranges is producing excessive smoke during broiling, the food might be too close to the broil element. Try lowering the rack position.
Why is the display flashing on my GE 400?
If your GE Ranges display is flashing, it likely indicates a power outage or surge. Reset the clock. If the oven was in use, press the Cancel pad, set the clock, and reset any cooking functions.
Why does my GE Water System have no water flow display when water is flowing?
If your GE Water System isn't displaying water flow when water is flowing, ensure the bypass valve is not in the bypass position. Also, check that the meter probe is fully inserted into the meter housing. If there's still no flow, remove the meter housing, free up the turbine, and flush it with clean water to remove any foreign material. The turbine should spin freely. If not, replace the meter. Another cause may be a defective meter probe.
Why is there steam from my GE 400 vent?
For steam from the vent of your GE Ranges, this is normal.
Why does my GE Ranges oven glass look tinted?
If the inner oven glass of your GE Ranges appears tinted or has a rainbow color, it is normal. The glass is coated with a heat barrier to reflect heat back into the oven, preventing heat loss and keeping the outer door cool.
Why do my GE Ranges racks slide out on their own?
If your GE Ranges racks slide in or out on their own, the unit might not have been properly leveled during installation. Level the oven by referring to the Installation Instructions.
Why does my GE 400 flash during self-clean?
If you see flashes in the display of your GE Ranges, it means the self-clean cycle has been selected, but the door isn't closed. Close the oven door.
What to do with water after GE 400 Ranges steam clean?
To address the issue of water remaining on the oven floor after a Steam Clean cycle in GE Ranges, remove any remaining water with a dry cloth or sponge.
Why isn't my GE 400 Ranges oven clean after self-clean?
If your GE Ranges oven is not clean after a self-clean cycle, it may be because the oven was heavily soiled. Clean up heavy spillovers before starting the cleaning cycle. For heavily soiled ovens, you may need to run the self-clean cycle again or for a longer period. Also, ensure that the oven controls are properly set; refer to the Care and Cleaning – Interior Surfaces section.
General| Self-Cleaning | Yes |
|---|---|
| Number of Burners | 4 |
| Width | 30 inches |
| Oven Type | Conventional |
| Cooktop Material | Glass |
| Color | Black |
To Next Page
