GE ADTS554F User Manual

ROUTINE MAINTENANCE
K0553 Revision D 126 [EN] English
Routine Maintenance
Absolute cleanliness of the work area, tools and equipment are essential.
Replacing the output connector o-ring
After inspection as detailed in maintenance task B, carry out the following if the o-ring is worn or
damaged:
Figure 5-1: Replacing the o-ring
1) Carefully remove the o-ring from the small groove at the top of the connector. Fit a new
o-ring in the small groove at the top of the connector.
2) Make sure the o-ring is tight in the groove and not damaged after fitting.
NOTE: Damage to this o-ring causes leaks.
Replacing a fuse
1) Disconnect the electrical power supply.
2) Unscrew the fuse holder cap and remove the fuse.
3) Only fit a new fuse of the correct type and rating into the fuse holder cap.
4) Secure the fuse holder in the front panel.

GE ADTS554F Specifications

General

Brand	GE
Model	ADTS554F
Category	Test Equipment
Language	English