20
Service Manual
Technical Information
Remote Control
To ensure proper operation, aim the remote control
at the signal receiver on the air conditioner.
The remote control signal has a range of up to 20
feet.Make sure nothing is between the air
conditioner and the remote control that could block
the signal.
Make sure batteries are fresh and installed correctly
as indicated on the remote control.
Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan
Speed for cooling. Use the Te mperature Increase/
Decrease pads to set the desired temperature be-
tween 64
The compressor will cycle on and off to keep the
room at the set level of comfort. Set the thermostat at
a lower number and the indoor air will become
cooler. Set the thermostat at a higher number and
the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned
on while set to a Cool setting or if turned from a fan
setting to a Cool setting, it may take approximately 3
minutes for the compressor to start and cooling to
For Maximum Cooling Select the Cool mode and
lower set temperature. For Quieter
Cool mode and L-
Energy Saver Mode
wider variations of room temperature a-
when the room is unoccup-
for a short ti-
cycles off.
Use the Fan Only Mode at Low, Med or High fan sp-
circulation and filtering without c-
not provide cool-
NOTE:Auto Fan Speed cannot be used when in the
Fan Only Mode.
Auto Fan Speed
Set to Auto fan speed for the fan speed to autom-
speed needed to provide optim-
temperature.If
NOTE:Auto Fan Speed cannot be used when in the
Fan
Only Mode.
Power Outage Recovery Feature
In the case of a power outage or interruption, the u-
cally restart in the settings last used
the Delay 1-24hr feat-
countdown
For Normal Cooling Select the Cool mode and
High
or Med fan with a middle set temperature.
Delay OFF-When the air conditioner is on,it can be
set to auto matically turn off in 1 to 24 hours.
How to set:
pad on the remote control. Each touch of the Increase/
Decrease pads on the unit or the Increase + / De-
crease - pads on the remote control will set the timer
in 1 hour intervals.
The Set
light will turn on while
To review the remaining time on the Delay 1-24hr
timer, press the Delay 1-24hr pad on the unit or
the DELAY pad on the remote control. Use the Increase/
Decrease pads on the unit or the Increase+/De-
crease- pads on the remote control to set a new
time if desired.
Press the Delay 1-24hr pad on the unit or the DELAY
F in 1F increments.F and 86
The fan will cycle on and off with the compressor.T-
in
Fan Only Mode
setting.
according to
the
with a
oling Select the
temperature.
results
Normally used
fan
may
continue
to
run
ovide air
only settings do
not be entered. The room
display.
to the
with the set
the fan speed will
less cooling,
automati
wer
is restored. If
to
set
a
ne
w
time
if
High
fan
& Night time Co
ow fan with a middle set
his
nd humidity.
ied. NOTE:The
me after the compressor
eed to pr
ooling. Since fan
ing, a Set temperature can
temperature will appear in the
atically set
um comfort settings
the room needs more cooling,
automatically increase.If the room needs
will automatically decrease. the fan speed
nit will
after the po
ure was set, it will
.You
may
need
morized time
me-
desired.
or Delay button on the remote controller to c-
setting,press Delay 1-24hr button on the panel
During preview of time or timer
ancel the timer setting.
To Next Page
Loading...
