GE AEE07KP - Unit Control Panel Operations

29
Service Manual
Technical Information
AED07KP,AED09KP,AED12KP
1
POWER BUTTON
2
FAN SPEED BUTTON
3
4
TEMP/TIMER BUTTON
MODEBUTTON
5
SIGNAL RECEIVER
6
SWING BUTTON
7
FILTERBUTTON
2
3
7
1
5
6
4
4
Operation starts when pressing this button, and stops
when pressing this button again.
Activate the automatic air swing function.
Select the fan speed TURBO, HIGH, LOW and AUTO
in sequence.
Press the keypad to increase the set (operating)
temperature of the unit and Press the keypad to
decrease the set (operating) temperature of the unit.
The temperature seting range is from 16~30
ć
Press the keypad also to increase the selected time
in 0.5 hour increments,and Press the keypad to
decrease the selected time in 0.5 hour decrements,the
time seting range is from 0.5~24 hours.
Select the operation mode, COOL, DRY, FAN
This feature is a reminder to clean the Air Filter (See
Care and Cleaning) for more efficient operation and
cooling.The LED (light) will illuminate after 250 hours
of operation.To reset after cleaning the filter , press the
"Check Filter" button and the light will go off.
SWING
ON/OFF
FAN
SPEED
TURBO
HIGH
LOW
AUTO
COOL
MODE
TIMER
FILTER
DRY
FAN
NOTE:
Control panel is capable of displaying temperature in degrees Fahrenhei
t
or degrees Celsius,To convert from one to the other, Press and hold the
Up and Down buttons on Control panel together for 3 seconds.
(61~86 F)
o
Remote control panel