GE AF-300 P11 - Page 146

13-3
Data subject to change without notice 7/07. © 2007 GE Drives
Name Analog I/O Interface Card
Type
Function
2 analog outputs (1 voltage output and 1 current output): 11 types of data can be output.
Specifications Input Analog signal input (3 points) 32 and 31, 22 and 21, C2 and 21.
Terminal 32: Voltage input (both sides): 0 to ±10 VDC / 0 to ±100%, input impedance: 22k ohm.
Terminal 22: Voltage input (both sides): 0 to +10 VDC / 0 to +100%, input impedance: 22k ohm.
Terminal C2: Current input: 4 to + 20mADC / 0 to +100%, input impedance: 250k ohm.
For voltage input, power supply terminal for variable resistor (P10) should be connected.
Related function code o22
Output Analog signal input (2 points) between AO+ and AO-, CS+ and CS-
Terminal AO+: Voltage output: 0 to ±10 VDC, for max. 2 voltmeters, input impedance: 10k ohm
Terminal AO-: Voltage output common.
Terminal CS+: Current output: 4 to 20mAdc, max. 500 ohm
Terminal CS-: Current output common
(Terminal CS- is isloated from terminal 21, 31 and AO-)
Related function code o23
Connection
diagram
Remarks
3 analog inputs (2 voltage inputs and 1 current input): Torque limiting value (driving, braking), frquency setting, ratio setting
can be input respectively.
OPCG11SAIO
X9
X8
X7
X6
X5
X4
X3
X2
X1
E(G)
SD
DX
A
DX
B
FM
P
FM
A
CM
CM
REV
FW
D
PLC
CM
E
AO-
AO+
C2
21
22
31
32
Y1
Y2
Y3
Y4
Y5C
Y5A
C1
11
12
13
30C
30B
30A
(T0) *
AF-300
P11
MCCB
or
ELCB
* Terminals [R0] and [ T0] are no t provided f or 1.0 HP o r s m a ll e r.
RUN command
input
(R0) *
M
U
V
W
L3/T
L2/S
L1/R
CS+
CS-
(+)
(- )
(+)
VR
VR
( 1k ohm)
(1k ohm)
Voltage input
(Single polarity)
Voltage input
(Both polarity)
Current input
Analog voltmeter
Anammeter