Need help?Do you have a question about the GE PAC8000 series and is the answer not in the manual?
General| Series | PAC8000 |
|---|---|
| Type | Programmable Automation Controller |
| Mounting | DIN rail |
| Input Voltage | 24 VDC |
| Communication Protocols | Modbus TCP/IP, Modbus RTU |
| I/O Modules | Digital, Analog |
| Power Supply | 24 VDC |
| Certifications | UL, CE |
Explains the use of warning notices for personal injury risks.
Explains the use of caution notices for equipment damage risks.
Lists technical specs like PROFINET support, dimensions, power, and operating range.
Details on mounting the PNS module on a DIN rail and required clearances.
Information for products with UL/ATEX markings for hazardous locations.
Instructions for connecting single or redundant power supplies.
Details on updating the PNS module's firmware.
General information on configuring PNS and IO modules in a PROFINET network.
Covers adding the scanner to a LAN, configuring parameters, redundancy, and module settings.
Procedure for replacing a faulty PNS module.
Covers methods for handling fatal errors and PROFINET diagnostics.
Describes how the PNS manages and reports fatal errors.
To Next Page
