GE PAC8000 series

Index
GFK-2839B PAC8000* IO PROFINET Scanner User’s Manual–September 2017 19
Chapter 2. Hardware Installation
This chapter describes:
■ Module Installation
o Installing the Module on a DIN Rail
o Removing the Module from the DIN Rail
o Panel-Mounting
o Grounding
o Installing Power Supplies
■ PNS Powerup and Restart
■ LED Operation
o Special LED Blink Patterns
■ Firmware Updates
o Installing the USB Port Driver
2.1 Module Installation
PNS module must be mounted on a horizontal DIN rail. The PNS module fits into a 156mm
deep enclosure.
Rated thermal specifications are based on a minimum clearance of 5.1cm (2 inch) above and
below the module.
In addition to clearances required for cooling, space must be allowed for the following
requirements:
Allow adequate clearance for communications port cables. For an example, see
below sections.
Allow adequate clearance for power wiring.
1
2