Index
GFK-2839B PAC8000* IO PROFINET Scanner User’s Manual–September 2017 23
2.4 Installing the Module on a DIN Rail
The PNS and connecting carriers must be installed on the same section of 35mm x 7.5mm
DIN rail. The rail must have a conductive (unpainted) finish for proper grounding. For best
resistance to vibration, the DIN rail should be installed on a panel using screws spaced
approximately 6 inches (5.24cm) apart.
Step 1 Slide the Carrier module onto the DIN rail thru the recess provided on the carrier plastic
Step 2: Lock the carrier in place with four screws marked through the hole on module
To Next Page
Loading...
