Without the drive reporting a fault condition. Note that this light only means
that the drive output contactor is energized and the panel is operating in “Drive”
mode. If the motor’s shaft is not rotating then it may be due to 1) no run
command provided to the drive (i.e. H-O-A switch in the “Off” position) 2) No
Speed ref.
Drive Fault Indicator This optional orange light on the panel door indicates that the inverter is
reporting a fault condition. If your panel was ordered with the optional
automatic bypass functionality the panel will automatically switchover to
“Bypass” mode of operation following an inverter fault trip.
DEH40602 – Page 7 AN 11-2021 Rev 05, 12/15/2011
To Next Page
Loading...
