E-0 # Digital Inputs
Ok
5 Times downward arrow
Ok
SET TO [14] JOG
Ok
Auto-Tune
In the event that it is desired to “auto-tune” the drive to the connected motor, reference the following
instructions along with the AF 600 FP User’s Guide (DET – 609 or DET - 610):
With power applied to the panel –
1) Place the Test/Isolate/Normal, Hand/Off/Auto, and Drive/Off/Bypass selector switches in the “Normal”,
“Off”, and “Drive” positions respectively.
2) For Full Auto tuning follow the instruction below
Quick Menu
Ok
Quick start
Ok
Once Up arrow
Ok
P-04 Auto Tuning
Ok
[1] Full Auto tune
Ok
Follow the Keypad direction
Note: If the panel has a load reactor, select “Reduced Auto tune”.
DEH40602 – Page 18 AN 11-2021 Rev 05, 12/15/2011
To Next Page
Loading...
