In-Warranty Information Form
The purpose of this form is to provide specific information to GE Drives to aid in expediting part
replacement and/or troubleshooting assistance for AF-600 FP Bypass OR NON Bypass OR Disconnect
Drive panels. The following information is required prior to any assistance being provided.
Panel Model Number :
Panel Serial Number :
Start-Up Date :
Failure Date :
I. Application Information:
Input Transformer: _____ kVA Wiring distance between motor & drive ______ ft.
Power Factor Correction Capacitors: _____ Yes ( _______ Microfarad) _____ No
Other Equipment on Same Power: _____ Yes _____ No
If Yes, what? ______________________________________________________
II. Function Code Different From Factory Settings:
FC Setting FC Setting
III. Failure Message:
Latest Fault Previous Fault
IV. Status When Failure Occurred (check one):
_____ Power Up _____ Running _____ Inverter Mode _____ Bypass Mode
V. Description Of Failure:
______________________________________________________________________________
______________________________________________________________________________
Once all the required information above is acquired, contact the following number for assistance:
GE Industrial Systems
phone: 1-800-533-5885 (24hrs.)
DEH40606 – Page 1 AN 11-2021 Rev 04, 12/15/2011
To Next Page
Loading...
