GEAppliances.com
Do Not Operate in Freezing Outdoor Conditions
Thiscool-only air conditioner was not designed for
freezing outdoor conditions. It must not be used in
freezing outdoor conditions.
Remote Control
To ensure proper operation, aim the remote
control at the signal receiver on the air
conditioner.
Theremote control signal has a range of
up to 20 feet.
Make sure nothing isbetween the air conditioner
and the remote control that could block the
signal.
Make sure battery isfresh and installed correctly
as indicated on the remote control.
Cool Mode
Usethe Cool mode at Low, Med, High or Auto
Speedfor cooling. Usethe Temperature Increase •
/ Decrease• padsto set the desired temperature
between 61% and 86% in 1% increments.
An electronicthermostat isusedto maintain the room
temperature. Thecompressorwill cycleon
and off to keepthe room at the set levelof comfort.
Setthe thermostat at a lowernumber and the indoor
air will become cooler.Setthe thermostat at a higher
number and the indoor air will becomewarmer.
NOTE:Ifthe air conditioner isoff and is then turned on
while set to a Cool setting or if turned from a fan
setting to a Cool setting,it may take approximately
3 minutes for the compressor to start and coolingto
begin.
Cooling Descriptions
For Normal Cooling-Select the Cool mode and
High orMed fan with a middle set temperature.
For Maximum Cooling--Select the Cool mode
and High fan with a lower set temperature.
For Quieter and Nighttime Cooling-Select the
Cool mode and Low fan with a middle set
temperature.
Energy Saver Mode
Controls the fan.
ON--The fan will cycleon and off with the
compressor.This results in wider variations of room
temperature and humidity. Normally usedwhen the
room isunoccupied. NOTE:Thefan may continue to
run for a short time after the compressorcyclesoff.
OFF--Thefan runsall the time, while the compressor
cycles on and off.
Fan Only Mode
Usethe Fan Only Modeat Low, Medor High fan
speedto provide air circulation and filtering without
cooling. Sincefan-only settings do not provide
cooling, a Settemperature cannot be entered. The
room temperature will appear
in the display.
Auto Fan
Setto Auto for the fan speedto automatically set
to the speedneeded to provide optimum comfort
settings with the set temperature.
If the room needs more cooling, the fan speed
will automatically increase. Ifthe room needs less
cooling, the fan speedwill automatically decrease.
To Next Page
Loading...
Need help?
General
