GEApplMnces.com
COOL MODE
Remote Control
1,Press COOLpad,
2,PressLOWor HIGHpads to set desired fan speed,
3,Pressthe INCREASE+ / DECREASE- pads to set the desired
temperature 60°Fto 85°Fin 1°Fincrements,
Control Panel
1,Pressthe MODEpad until the COOL indicator light is lit,
2,Pressthe FANpad until HIGHor LOWindicator light
islit for desired fan speed,
3,Pressthe INCREASE+ / DECREASE- pads to set the desired
temperature 60°Fto 85°Fin 1°Fincrements,
A thermostat is used to maintain the room temperature, The
compressor will cycle on and offto keep the room
at the set level of comfort, Setthe thermostat at a lower
number and the indoor air will become cooler,
Setthe thermostat at a higher number and the indoor air will
become warmer,
NOTE:If the air conditioner is off and Lsthen turned or7while set
to COOL,it will take approximately 3 minutes
for the compressor to start and cooling to begin,
Cooling Descriptions
For Normal Coofing-Select the COOLmode and HIGHfan
with a middle set temperature,
For Maximum Cooling-Select the COOLmode
and HIGHfan with a lower set temperature,
For Quieter and Nighttime Cooling-%lect the COOLmode
and LOWfan with a middle settemperature,
NOTE."Therewill be a 3-minute delay between setting
changes such as COOLto OFFand back to COOL.
HEAT MODE
Remote Control
1,Press HEATpad,
2,Press LOWor HIGHpads to set desired fan speed,
3,Pressthe INCREASE+ / DECREASE- pads to set the desired
temperature 60°Fto 85°F in l°F increments,
Control Panel
1,Pressthe MODEpad until the HEATindicator light is lit,
2,Pressthe FANpad until HIGHor LOWindicator light
is litfor desired fan speed,
3,Pressthe INCREASE+ / DECREASE- pads to set the
desired temperature 60°Fto 85°F in 1°Fincrements,
A thermostat is used to maintain the room temperature, The
heater will cycle on and off to keep the room
at the set level of comfort, Set the thermostat at a higher
number and the indoor air will become warmer,
Set the thermostat at a lower number and the indoor air will
become cooler,
NOTE."If the air COrTdit/onerL_off and L_then turned on while set
to flEA T,it will take approximately 7 minute
for the heater to start and heat/ng to begin,
Heating Descriptions
For Normal Heating-Select the Heat mode and HIGHfan
with a middle set temperature,
For Maximum Heating-Select the HEATmode
and HIGHfan with a higher set temperature,
For Quieter and Nighttime Heating-Select the HEATmode
and LOWfnn with a middle set temperature,
FAN
Usethe F/INto provide air circulation and filtering without
cooling or heating, Sincefan only settings do not provide
cooling or heating, a temperature setting will not be displayed,
Remote Control
PressF/INpad, PressLOWor HIGHpads to set desired fan
speed,
Control Panel
Pressthe MODEpad until the F/INindicator light is lit
and the LOWor HIGHindicator light is lit for the desired fan
speed,
To Next Page
Loading...
