GE Built-In Wall Oven - Cabinetry: Oven Over Warming Drawer (27); Single Oven Installation; Double Oven Installation; Warming Drawer Electrical Requirements

Cabinetry
Cutout for 27" (68.6cm)Single or
Double Built-In Ovens only- Over a
Warming Drawer
For JKS10, JKP30, JKP35, JKP55, JKP70, JKP75, PK916, PK956, ZEK938,
ZEK958 models only.
Single 27" (68.6 cm)
Oven Over
a Warming Drawer
Double 27" (68.6 cm)
Oven Over
a Warming Drawer
Per
Warming
Drawer
Requirement
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
3" (7.6 cm)
Min,
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
1" (2,6 cm) Min, Above Toekick or
Adjust to Oven Installation Height
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height,
Anti-Tip Block
Against Rear
•Wall Per
Warming
Drawer
Requirement
3" (7.6 cm)
Min.
Per Warming
Drawer
Req_
1" (2.6 cm) Min. Above Toekick
• When installing a Warming Drawer below
a single or double oven, a separate 120V,
60 Hz, properly grounded receptacle must
be installed. Refer to installation instructions
packed with the Warming Drawer for
specific installation requirements.
7