GE CareScape V100 - Exergen TAT; Cable Replacement

6-44 CARESCAPE V100 Vital Signs Monitor 2048723-002C
Parts lists and drawings: Disassembly/reassembly of FRUs
review all material included in your kit.
Exergen TAT
Cable replacement
1. Turn off the monitor and unplug the cable from the host communication
port on the back of the monitor.
2. On the back of the scanner, loosen the single screw at the bottom.
3. Remove the battery door.
4. Remove the cable.
5. Install the replacement cable. Making sure both keyways line up, install male
connector completely into the female jack inside the scanner.
6. Tighten the battery screw.