2-4 CARESCAPE V100 Vital Signs Monitor 2048723-002C
Equipment overview: Front panel indicators
9. Cycle button: used to select NIBP mode of manual, auto cycle, or Stat mode.
10. Temperature probe cover storage: stores Alaris probe covers.
11. History button: activates the history mode to view stored patient data. The
most recent entries are displayed first. Press and hold the button for 2
seconds to clear all entries stored.
12. Print button: prints currently displayed values or all stored entries when in
history mode.
13. On/Off button: controls on/off state of monitor; push for power on and push
again for power off.
14. Alaris temperature probe connector: attach temperature probe cable here.
(The Exergen scanner connects to the host communication port at the back
of the system. Refer to “Rear panel” on page 2-6).
Front panel indicators
15. Alarm silence indicator:
Solid red: Indicates that an alarm silence is active and the audible alarm
tones are silenced for 2 minutes.
Blinking red (Legacy alarm mode only): Indicates that an alarm silence is
not active and at least one alarm condition is present.
16. Systolic window: indicates measured systolic NIBP in mmHg.
17. Diastolic window: indicates measured diastolic NIBP in mmHg.
18. INFLATE PRESSURE indicator: flashes to indicate you are making a change
to the inflation pressure. Adjustable for adult/ped and neonate patients.
19. ALARM VOLUME indicator: flashes to indicate you are making a change to
the alarm volume.
20. PULSE VOLUME indicator: flashes to indicate you are making a change to
the pulse volume.
HISTORY
AUTO CYCLE
MAP/Cuff
BATTERY
Pulse Rat e
Temperature
Sp O
C
F
Diastolic
Sy st o l i c
ALARM VOLUME
HIGH
HIGH
HIGH
HIGH
LOW
LOW
LOW
LOW
CH ARGI NG
PULSE VOLUME
I NFLA TE PRESSURE
16
17
18
21
22
23
15
24
25
26
28
28
29
20
19
ADULT
NEONATE
30
31
OK
27
29
30
31
32
33
To Next Page
Loading...
