d. Changing Wireless Zone Settings:
i. If you need to change a zone setting – Enter Programming Mode, Press B to Scroll the
menu. Select “Sensors” # “Edit” # Select the Zone you wish to Edit, and make the desired
changes pressing # to save the desired changes.
e. Exiting Programming Mode
i. After all installer/dealer programming is completed, use the following procedure to exit
programming mode.
To exit programming mode:
1. Press * until the display shows SYSTEM PROGRAMMING.
2. Press A or B until the display shows EXIT PROGRAMMING READY.
3. Press # and the touchpad displays the TIME AND DATE.
f. Using The System
i. Setup User Codes:
1. To Enter User-Programming Mode
a. Press 9 then the 4 digit Master Code (Default is 1234)
2. Scroll Menu using the B Button until you reach “User”
3. With the display showing USER CODES, press # and the display shows REGULAR
USER CODES.
4. Press # and the display shows USER nnn (first available user number).
5. Press A or B to select the desired user number, and then press #. The display
shows USER nnn - nnnn.
6. With the desired user number displayed, enter a 4-digit user code. The display
flashes the entered code. Press # and the display shows USER nnn - nnnn (new
code).
To Next Page
Loading...
